Skip to content
English
Go to LiteGait.com
  • There are no suggestions because the search field is empty.

Knowledge Base: Pairing and Calibrating GaitSens (Tablet Setup)

This article explains how to pair a tablet to a GaitSens-enabled treadmill and complete calibration. Use this when setting up a new tablet or after replacing a tablet/treadmill component.  Your screens may look different from these images, but the steps are the same.

Prerequisites

  • GaitSens-enabled treadmill powered ON.
  • Tablet charged and powered ON.
  • Tablet is within a few feet of the treadmill during pairing.
  • GaitSens app installed and available on the tablet.
  • Bluetooth enabled on the tablet (if required by your model/workflow).
  • Use only Mobility Research certified tablet.

Procedure

  1. Swipe down from the upper right corner of the screen to reveal the quick launch drawer. Press and hold “Bluetooth”.
    GaitSens Setup (1)
  2. Select Details.
    GaitSens Setup (2)
  3. If Bluetooth is turned off, turn Bluetooth on. You should see an available device that starts with “GS2000”.
    GaitSens Setup (3)
  4. Open the GaitSens app.
    GaitSens Setup (4)
  5. From the dropdown in the upper right, select “Configuration”. When prompted, enter “mobility” as the password.
    GaitSens Setup (5)
  6. In the GaitSens, select your paired treadmill (#1 in green), then select your model of treadmill (#2 in pink), and then press “Start” (#3 in orange). Wait for the treadmill to connect.
    GaitSens Setup 8-1
     
  7. Click on “Calibrate” and follow the on-screen prompts to complete calibration.
    GaitSens Setup 7
  8. Click on “Exit” to save settings and go to the main therapist screen.
    GaitSens Setup 9

  9. On the upper left, click on one of the two icons to either create a new patient or select an existing patient.
    GaitSens Setup 10

  10. Click on the red button to start the session and confirm it works. Please verify that the speed sensor is displaying the correct speed and that the patient’s weight is accurately displayed regardless of where they stand on the belt.
    GaitSens Setup 11

Notes and Troubleshooting

  • Device not found: Confirm the treadmill is powered on, keep the tablet close, and retry pairing.
  • Pairing fails repeatedly: Turn Bluetooth off/on (if used), restart the tablet, then retry.
  • Connects but no data: Close and re-open the GaitSens app; confirm the correct treadmill/device was selected.
  • Calibration won’t complete: Restart the calibration workflow and carefully follow each on-screen prompt. If calibration still fails, confirm nothing is touching the treadmill, incline wheels are not touching the ground (if applicable) and the feet are adjusted to be similar lengths. If this does not resolve the issue, contact Mobility Research for assistance.

Contact Information for Support